Page 18 KM3000 KM4000 Operating Manual
If the front clamp is used on diameters smaller than 2.6" (66 mm), the
machine will produce undesired work results.
CLIMAX electrical equipment is suitable for use in the physical environment and
operating conditions specified below. When the physical environment or the oper-
ating conditions are outside those specified, consult CLIMAX before putting the
electrical equipment into service.
Maximum shaft diameter (standard bar
clamp):
4.5" (114.3 mm) 18.0" (457.2 mm)
Maximum shaft diameter (with optional
chain clamp):
10.5" (266.7 mm) 24.0" (609.6 mm)
Minimum shaft diameter (standard bar
clamp)
1
:
1.5" (38.1 mm) 8.0" (203.2 mm)
Minimum shaft diameter (with optional
shim kit on rear clamp only)
2
:
0.75" (19.1 mm) 4.0" (101.6 mm)
Minimum clamping space required on
stub shaft:
1.5" (38.1 mm) 8.0" (203.2 mm)
Minimum clamping space required on
obstructed shaft:
NA 10.5" (266.7 mm)
3
Minimum shaft diameter for rear clamp
4
: 1.5" (38.1 mm) NA
Minimum shaft diameter for front clamp: 2.6" (66 mm) NA
Diameter of one end mill included: NA 0.75" (20 mm)
Shipping weight: 82 lb (37.3 kg) 195 lb (89 kg)
Machine weight (with speed control): 70 lb (31.8 Kg) 250 lb (114 kg)
Shipping size:
13" x 14" x 20"
(330 x 360 x 510 cm)
24" x 24" x 19”
(610 x 610 x 483 mm)
1. See notice below.
2. See notice below.
3.The KM4000 can cut keyways within 2.2" (55.88 mm) of the obstruction.
4. See notice below.
TABLE 2-10. KM3000/KM4000 SPECIFICATIONS
KM3000 KM4000
TABLE 2-11. ELECTRICAL SPECIFICATIONS
Mains voltage (AC): ±10% of nominal
Mains frequency (AC): ±1% of nominal
Mains harmonics:
10% of RMS volts
2nd through 30th harmonic
Voltage imbalance (3-phase supplies): 2% maximum
To Next Page
Loading...
