Climax KM3000 - Cross Slide ); Km4000 Lateral Feed ( Cross Slide )

P/N 104075, Rev. 0 Page 39
10. Remove the end mill from the spindle.
11. Remove the key mill from the shaft.
4.5 KM4000 LATERAL FEED (CROSS SLIDE)
Hand crank the cross slide leadscrew. One complete turn of the leadscrew will
move the key mill 0.100" (2.50 mm on metric machines).
FIGURE 4-3. KM4000 FEED COMPONENTS
TABLE 4-1. FEED COMPONENTS IDENTIFICATION
Number Component
1 Quill and spindle
2 Cross slide lead screw
3 Base
1
2
3