All content © 2020, cmotion GmbH. All specications are subject to change without further notice.
http://www.cmotion.eu
page 71 of 120
6.2.3.3.13. Set iris
The set iris menu allows you to enter a xed iris value if motor is not assigned to the iris
scale. This allow a valid depth of eld (DOF) to be calculated with the variable data that
is available.
Note: A lens le needs to be loaded. Set iris uses a xed iris value when the axis is not
motorized. This value needs to be changed each time the iris is changed on the lens.
6.2.3.3.14. Set zoom
The set zoom menu allows you to enter a xed zoom value if motor is not assigned to the
zoom scale. This allow a valid depth of eld (DOF) to be calculated with the variable data
that is available.
Note: A lens le needs to be loaded. Set zoom uses a xed zoom value when the axis is not
motorized. This value needs to be changed each time the zoom is changed on the lens.
6.2.3.3.15. Circle of confusion
The circle of confusion menu allows you to enter a value depending on your cameras
sensor size and image format to calculate an accurate depth of eld based on variable
lens data.
Note: A lens le needs to be loaded. This value needs to be set before shooting with a new
camera. For the correct circle of confusion value for your camera, please refer to the camera
manual or contact the camera manufacturer.
6.2.3.3.16. Sync cam data
The Sync cam data feature allows you to:
1. Upload ARRI LDS and Cooke /i data from a corresponding lens to your cPRO / cPRO
PLUS / cPRO ONE hand unit automatically (compatible with ARRI cameras only).
2. Feed FIZ metadata for any lens from the cPRO LCS to selected cameras (compatible
with ARRI Alexa Mini/ Mini LF, ARRI Amira, RED and Sony Venice).
Turn sync cam data “on” if you want to load lens data from ARRI cameras automatically,
or if you want to feed FIZ metadata to a compatible camera. If you do not want to use this
feature, ensure sync cam data is set to “o”.
Note: The sync camera data feature requires a DATA license key. Please also refer to section
“6.2.3.9.4. Licenses” on page 101 in this manual.
To Next Page
Loading...