Before you can connect to the router and start configuration procedures, your computer must be able to
get an IP address automatically (use dynamic IP address). If it’s set to use static IP address, or you’re
unsure, please follow the following instructions to configure your computer to use dynamic IP address:
If the operating system of your computer is….
Windows 95/98/ME - please go to section 2-4-1
Windows 2000 - please go to section 2-4-2
Windows XP - please go to section 2-4-3
Windows Vista - please go to section 2-4-4
2.4.1 Windows 95/98/ME IP address setup:
1. Click ‘Start’ button (it should be located at lower-left corner of your computer), then click control
panel. Double-click Network icon, and Network window will appear. Select ‘TCP/IP’, then click
‘Properties’.
To Next Page
Loading...
