A: There are two ways to find it.
1: Please check with your ISP.
2: Please select Log & Status on the left menu of the 3.5G server router, and then select
Network Configuration, you will see the WAN IP address.
3. Q: How do I know that I have static IP address on WAN?
A: Please check with your ISP, or select Network Configuration to check out.
4. Q: Can I use personal domain name on this router? Or should I use the IP address which
provided by router?
A: Yes, you can use your own domain name on 3.5G server router.
9.4 Operating System Setting
1. Q: My computer can’t connect to the Internet after installed the 3.5G server router, why?
A: Please follow the instructions ：（Windows 2000 & XP） Start > Settings > Network
Connections > double click Local Area Connections > select Properties > double click
Internet Protocol
（TCP/IP）> select obtain an IP address automatically > click OK. Then
open your browser to try again. If you still can’t connect to the login page, please test the
following methods：
Make sure there is no one using the same IP address.
Turn off the computer, then ping the IP was given to that computer, make sure there is no other
device responding.
Check the network cable connection condition, or use another cable to test again.
2. Q: Why can’t I use the utility?
A: Solution 1: Check out your Ethernet connection and power adapter.
Solution 2: Make sure that the IP address of your computer is located between 192.168.1.2
and 192.168.1.254. The Subnet Mask should be 255.255.255.0. The default Gateway is
192.168.1.1. To confirm these settings, please follow the instructions below.
Windows 95 or 98:
1. Click Start > Run > input winipcfg > click OK.
To Next Page
Loading...
Need help?
General