If the WEP of wireless router is enabled, your computer also needs to activate WP. The key
from both sides should match, too.
It might be interrupted by other radio frequency. Please check the status when close to the
wireless router. Bad communication environment is like 100 feet of normal situation.
3. Q: The speed of wireless connection is very slow.
A: For the best connecting speed, you can try to:
Location: Please adjust the location and direction of your router.
Channel: Change to another channel can avoid the interruption.
Interruption: It might be interrupted by other devices. You can turn off other devices first, and
then reconnect. Any noisy device should be avoided or relocated.
Shielding Effect: The speed might be impeded by your environment between wireless clients.
Close to station is the only way to improve the speed.
4. Q: When I use the wireless router, there are some applications not functioned properly.
A: You may activate DMZ service to run these applications, but be aware of following issues.
It may cause security problem if the firewall is disabled.
Only one computer can use DMZ service.
5. Q: I can’t make a connection with the wireless router.
A: Check out the following:
Check out the installation of router, the connection of local area network, and the power.
Make sure your computer is located on the same network class with wireless router.
If your computer is set to Obtain an IP Address automatically（DHCP client）, please reboot
it.
If your computer uses the static IP address, please confirm the IP address is located between
192.168.1.129 ~ 192.168.1.253. The default IP address for wireless router is 192.168.1.254.
The Subnet Mask is 255.255.255.0.
To Next Page
Loading...
Need help?
General