coatmaster Flex
5.2. Signs and Icons
Symbol Definition
This symbol means that your device meets the safety requirements of all applicable EU
directives.
This symbol means that you may only dispose the device at an approved local disposal
site.
Information: A highlight containing particularly important information for better
understanding.
Table 3: Signs and icons
Intended Use
The coatmaster® Flex is intended exclusively for the measurement of coating thicknesses.
The device should only be used as a handheld device. The device should not be mounted on a robot or
fixture or operated for an extended period of time.
The instrument may only be operated and cleaned by trained personnel. The intended use also
includes compliance with these instructions and the maintenance intervals must be observed.
Have your device repaired only by qualified personnel and only with original spare parts. This ensures
that the safety of the device is maintained.
The device is not approved for operation in environments with potentially explosive atmospheres.
Keep the device away from rain or moisture. Penetration of water into an electrical appliance increases
the risk of electric shock. Do not place the measurement device in a place where components could
come into contact with corrosive gases or salty air.
Do not block ventilation openings. The ventilation openings prevent the interior of the unit from
overheating.
Remove the battery before cleaning. Do not use solvents for cleaning, to avoid damaging the housing
surface. Use a clean, dry cloth.
In accordance with Directive 2012/19/EU, please take old parts to the appropriate recycling facilities
for proper disposal, reprocessing, and reuse. Never throw electrical equipment into the household
waste! By properly disposing of the electrical appliances, you help to protect valuable resources and
prevent possible negative effects on health and the environment, which could otherwise occur due to
improper waste disposal. Accessories and packaging should also be recycled in an environmentally
friendly manner.
5.3. Improper Use
Use not mentioned above or use that does not comply with the technical specifications, is considered
to be improper use. The operator is solely responsible for any damage caused by improper use.
To Next Page
Loading...
Need help?
General