coatmaster Flex
5.4. Product Safety
The measuring device has been designed and built with the latest state-of-the-art technology;
however, risks to users, property, and the environment may arise if the measurement device is used
carelessly or improperly, for which coatmaster AG bears no responsibility.
The following applications are prohibited:
•
Use of the equipment in environments where liquids may get into the device.
• Introduction of any objects into the coatmaster® Flex or similar devices.
•
Unauthorized opening the device, other than for standard maintenance operations (see
section 13.), voids the warranty and the manufacturer assumes no liability.
The measurement process is started by pressing the trigger button Ⓣ. When pressing the trigger
button to conduct a measurement, a light impulse is released.
The equipment has been tested in accordance with the safety requirements for electrical equipment
for measurement, control, and laboratory use (IEC 61010-1:2010) and the Low Voltage
Directive2014/35/EU.
To ensure photobiological safety for the user coatmaster® Flex (SpectralBlue® model) was thoroughly
tested. The operation by the end-user is classified as safe according to IEC 62471:2006.
5.5. Compatibility with flame detectors
The coatmaster® Flex has been tested and is compatible in operation with the flame detectors listed
below.
STS FL 7-64, 8-64 and 9-64. Note: must be set to UV+IR mode!
Minimax
Conditionally compatible: YMX 5000 FMX EX 90° IR (for
Total Walther UV-03
Table 5: Flame detectors compatible with Flex
Before operating the coatmaster® Flex in any environment, check if the measurement area is under
surveillance of flame detectors. If the flame detector is not listed in the above table, use the Flex in
that area after receiving written confirmation either from coatmaster AG or from the supplier of the
flame detector only.
To Next Page
Loading...
Need help?
General