coatmaster Flex
13.1. Replacement of the Inlet Filter
The inlet filter must be inspected, at least weekly, by the user of the coatmaster® Flex to avoid a
malfunction of the device. If it is dirty, change the filter; otherwise, change the filter every second week
or after 80 hours of use, whichever is earlier.
Remove the bottom cover to examine the inlet
filter of the coatmaster® Flex.
The filter should be clean, as shown in Figure
65: Inlet filter replacement. If the inlet filter is
dirty, please exchange the inlet filter for the
one that has been provided with your
delivery.
Never reposition a reversed dirty
filter in the filter holder since this will
blow dust inside the coatmaster®
and damage the device. Always use
a clean, new filter.
Figure 65: Inlet filter replacement
Make sure that the filter is well positioned by
pushing it toward the handle before closing
the cover. The filter should cover the entire
grid surface and no space should be visible
after closing the filter cover, as
shown in Figure 66: Positioning of the inlet
filter.
Wrong Correct
Figure 66: Positioning of the inlet filter
Never attempt to clean the inlet and outlet filters with compressed air, since this will blow
the dust particles inside the coatmaster® Flex and possibly push the filters away from
their correct position.
13.2. Cleaning and Care
After cooling, clean the coatmaster® Flex with clean, dry, lint-free paper cloths. Never clean
the front glass or the lens with alcohol-based cleaners!
Do not clean the device with compressed air!
13.3. Warranty
Your coatmaster® Flex is covered by a one-year warranty.
To Next Page
Loading...
Need help?
General