Chapter 3: Calls, faxes and SMS
Use a phone or fax machine (SDU) 41
3333
To hold a call (SDU)
You can put an incoming, outgoing or local call on hold once the
connection is established. To place an active call on hold, press the hold
button on the phone. Once the call is put on hold, a ready tone will sound in
the handset. To reactivate the call, press the hold button a second time.
To place a call on hold using the Auxiliary handset, do as follows:
1. Press
F.
2. To reactivate the call, press
F.
To place a call on hold with the Full Feature handset, do as follows:
1. Press GT.
2. To reactivate the call, press GT.
To transfer a call (SDU)
An incoming or outgoing call can be transferred from one local phone A to
another local phone B connected to the same SDU.
Use the following procedure to make a call transfer using the Auxiliary
handset:
1. Press
F on phone A to put the call on hold.
2. On phone A, dial the desired handset, e.g.
K for handset #2. For local
numbers see Special-purpose and local numbers on page 40.
Which key works as a hold button varies from phone to phone.
To find out which button is the hold button on your handset, refer
to the phone’s user manual. On some digital phones, an R button
functions as the hold button (like for the Auxiliary Handset). On
analog phones without a dedicated hold button, a short press on
the hook button functions as a hold button (this is called the flash
button on analog phones).
Only one call can be placed on hold at the same time by a single
phone.
To Next Page
