Colortrac M25e - 2 Tools Required

M Series Service Manual
Page 6 of 129
2 Tools Required
To maintain the M Series the tools listed below are required. The tools are generally available;
they are not the responsibility of Colortrac to supply.
1. Wristband
 Anti-static and cable.
2. Pencil
 HB Lead
3. 7mm Nutdriver.
 To remove and fit M5 nuts.
4. 1.5mm Allen Key
 or 1.5mm Hex Key
5. Medium Pozi-drive screwdriver.
 PZ1 x 80mm length.
6. Small Pozi-drive screwdriver.
 PZ0 x 60mm length.
7. Small Flat Screwdriver
 3mm blade x 65mm length
(approx.)
8. Medium Flat Screwdriver.
 6mm blade
(approx.)
9. Pliers.
 Flat nosed pliers, short serrated.