InteliMains
NT
, SW version 3.0
InteliMains-NT-BTB-3.0-Reference Guide.pdf, ©ComAp – June 2013
14.2.1.19 Binary input: ManualLdRecon
This input is used for manual reconnection of the last disconnected part of
the load, if the load has dropped below the setpoint Ld recon level.
This input works only if automatic reconnection is disabled, i.e. the setpoint
AutoLd recon is set to DISABLED.
14.2.1.20 Binary input: FaultResButton
This input is used for an external FAULT RESET button mounted on the
switchboard. The function of the input is identical as function of the fault reset
button on the controller front panel.
The input is enabled only if the setpoint Local Button is set to position
EXTBUTTONS or BOTH.
14.2.1.21 Binary input: HornResButton
This input is used for an external HORN RESET button mounted on the
switchboard. The function of the input is identical as function of the horn reset
button on the controller front panel.
The input is enabled only if the setpoint Local Button is set to position
EXTBUTTONS or BOTH.
14.2.1.22 Binary input: BTBButton
This input is used for an external BTB button mounted on the switchboard.
The function of the input is identical as function of the BTB button on the
controller front panel.
The input is enabled only if the setpoint Local Button is set to position
EXTBUTTONS or BOTH.
14.2.1.23 Binary input: GroupLink
To Next Page
Loading...
Need help?
General
