InteliMains
NT
, SW version 3.0
InteliMains-NT-BTB-3.0-Reference Guide.pdf, ©ComAp – June 2013
NOTE:
The reaction on changes of these inputs is delayed about 1 sec to ensure the
new combination is valid (e.g. if a rotary selector switch is used).
CAUTION!
Each language change causes the reinitialization of the display. Function of
the controller is not influenced.
14.2.1.84 Binary input: Lang sel int B
This is one of three binary inputs Lang sel int A, Lang sel int B, Lang sel int
C, used for selecting language of the built-in IG-NT terminal (display). As the
IS-NT does not have built-in terminal, this input is assigned to the terminal
(display) #1, which is supposed to be directly attached to the controller or
mounted close to it.
NOTE:
Using these inputs for language selection is an option only. If the inputs are
not configured, the language can be selected using the menus on the
terminal.
ENCODING TABLE
NOTE:
"0" in the table means the input is not active or not configured.
To Next Page
Loading...
Need help?
General
