InteliVision 8
83
Read firmware
The function allows reading and saving of current firmware in InteliVision 8. When you click on Read Firmware
button “Save As” window appears Read firmware (page 83)and you can choose a location where you would
like to save the downloaded firmware.
Image 10.8 “Save as” option for InteliVision 8 firmware
Default location for firmware saving is:
c:\Documents and Settings\All Users\Dokuments\ComAp PC Suite\Tools\IVProg\
Name of the firmware is automatically created and it contains information about date and time: Ivp_
<YYMMDD>_<HHMMSS>.ivp.
Write firmware
The selected firmware is uploaded to InteliVision 8 by touch of this button.
Firstly window for selection of IV8 firmware appears. After choosing the appropriate firmware and its
confirmation, a warning message, if cable between PC and InteliVision is connected, appears Write firmware
(page 83).
Image 10.9 Warning message relating to connection
In case your PC is not connected to InteliVision 8, you should first create the connection using USB A/B cable
and then you can press OK. In case the connection is already established just press OK.
To Next Page
Loading...
Need help?
General
