CommScope ION-E Series - Removing an E-POI Module from an E-POI Subrack

ION
®
-E Series Hardware Installation Guide M0201AA
Page 40 © June 2017 CommScope, Inc.
Removing an e-POI Module from an e-POI Subrack
REMOVING AN E-POI MODULE FROM AN E-POI SUBRACK
TheION-ESoftwareautomaticallydetectswhenane-POIModuleisaddedtoane-POISubrack.Ifyouneedto
removeane-POIModule,youmustdothefollowing:
1 DisconnecttheRibboncablefromthee-POIModulethatyouareremovingfromthee-POISubrack.
2 Loosenthetwothumbscrewsonthebottomofthee-POIModuleandpullitfromthesubrack.
3 PresstheConfigbuttonontheIFCfor5seconds.ThistellstheION-ESoftwaretoscananddeletethe
removede-POIModulefrominventoryandclearanyalarmsrelatedtothate-POIModule.
4 Waitforthee-POIModuleStatusLEDSontheIFCtoflashoffandthenon,whichindicatesthattheIFChas
beenreconfigured.
e-Poi Module
1
2
3
4
IFC