Need help?Do you have a question about the CommScope ION-E Series and is the answer not in the manual?
General| Brand | CommScope |
|---|---|
| Model | ION-E Series |
| Category | Multi-service Platforms |
| Language | English |
Covers copyright notices and registered trademarks of CommScope, including legal disclaimers.
Provides a description of the ION-E system components like CAN, TEN, and UAPs.
Covers important information for working safely with ION-E hardware.
Lists general health and safety precautions to observe during operation.
Details FCC, IC, and EMC standards compliance requirements for the equipment.
Introduces WCS-4 and WCS-2 subracks and their role as CAN or TEN.
Identifies front panel slots, GUI, and back panel connectors for WCS subracks.
Describes the System User Interface, RF Donor, Optical Transport, Copper Transport, and Auxiliary Unit cards.
Provides instructions for rack-mounting subracks and PSUs.
Overviews the e-POI subrack and details its back panel connectors.
Describes the IFC for status/alarms and the e-POI module for RFD card interface.
Steps for installing and removing e-POI modules from the subrack.
Lists specifications for the e-POI subrack and its components.
Details PSU modules, connectors, and status LEDs for 12 Vdc and 57 Vdc modules.
Provides instructions for installing PSUs into the system.
Explains UAP identification in software and details the different UAP models.
Outlines the general steps required to install a UAP.
Covers standard and quick-release ceiling mount, and wall mount installation steps.
Details UAP maintenance, removal, and operational specifications.
To Next Page