303 - 02 Keyboard LED test, reset test failed
303 - 03 Keyboard LED test, reset test failed
303 - 04 Keyboard LED test, LED command test
failed
303 - 05 Keyboard LED test, LED command test
failed
303 - 06 Keyboard LED test, LED command test
failed
303 - 07 Keyboard LED test, LED command test
failed
------------------------------------------------------------------------------
Error
Codes Error Description Recommended Action
------------------------------------------------------------------------------
303 - 08 Keyboard LED test, command byte The following steps apply
restore test failed to error codes 301 - 01
through 304 - 06:
303 - 09 Keyboard LED test, LEDs failed to
light 1. Check the keyboard
cable connector. If
304 - 01 Keyboard typematic test failed disconnected, turn
off computer and
304 - 02 Unable to enter mode 3 connect keyboard.
2. Check internal keyboard
304 - 03 Incorrect scan code from keyboard connections to system
board.
304 - 04 No keyboard make code observed 3. Replace the keyboard
and retest.
304 - 05 Unable to disable typematic feature 4. Replace the system
board and retest.
304 - 06 Unable to return to normal mode
==============================================================================
Table 5-5. Parallel Printer Interface Test Error Codes
==============================================================================
Error
Codes Error Description Recommended Action
------------------------------------------------------------------------------
401 - 01 Printer failed or not connected The following steps apply
to error codes 401 - 01
402 - 01 Printer data register failed through 498 - 00:
402 - 02 Printer control register failed 1. If a printer is
connected, be sure it
402 - 03 Printer data and control register is turned on and in the
failed online mode.
2. Check the switch
402 - 04 Printer loopback failed settings on the
multipurpose fixed disk
402 - 05 Printer loopback and data failed drive controller board
or the multipurpose
402 - 06 Printer loopback and control registers controller board (see
failed Chapter 8, "Jumper