8. The VDU sweep board is secured to the system chassis by five PCB stand off
mounts and one screw. Using a Torx screwdriver, remove the grounding
screw in the upper left corner of the VDU sweep board. To remove the VDU
sweep, grasp the board and gently slide it upward until the standoffs
clear the mounting holes. Once the VDU sweep board clears all standoffs,
slide the board out of the mounting holes and let it come to rest on the
side of the VDU (Figure 7-67).
9. Remove the four screws from the front of the video display unit (Figure 7-68).
To Next Page
Loading...
Need help?
General