1210 - 05 XMIT exceeded carrier lost limit
1210 - 06 Timed out waiting for dial tone
1210 - 07 Dial number string too long
------------------------------------------------------------------------------
Error
Codes Error Description Recommended Action
------------------------------------------------------------------------------
1210 - 08 Modem timed out waiting for remote The following apply to
response error codes 1201 - xx
through 1210 - xx:
1210 - 09 Modem exceeded maximum redial limit
1. Refer to modem
1210 - 10 Line quality prevented remote documentation for
connection correct setup
procedures.
1210 - 11 Modem timed out waiting for remote 2. Check the modem line.
connection 3. Replace the modem and
retest.
1210 - 12 Modem timed out waiting for modem
response (analog loopback originate
mode)
1210 - 13 Modem exceeded data block retry limit
(analog loopback originate mode)
1210 - 14 DRIVER/RECEIVER data failure
1210 - 15 Modem detection failure
1210 - 16 Modem ROM, checksum failed
1210 - 17 Tone detection failure
1210 - 21 Modem timed out waiting SYNC
(analog loopback answer mode)
1210 - 23 Modem exceeded data block for retry
limit (analog loopback answer mode)
==============================================================================
Table 5-10. Fixed Disk Drive Test Error Codes
==============================================================================
Error
Codes Error Description Recommended Action
------------------------------------------------------------------------------
1700 - xx Fixed disk ID drive types test failed The following steps apply
to error codes 1700 - xx
1701 - xx Fixed disk drive format test failed through 1716 - xx.
1702 - xx Fixed disk drive read test failed 1. Check switch and jumper
settings on the fixed
1703 - xx Fixed disk drive write/read/compare disk drive controller
test failed board, multipurpose
fixed disk drive
To Next Page
Loading...
Need help?
General