Driving
unavailable or ACC unavailable warning
lights come on.
●
Clean the sensor area on the bumper as
indicated in
›››
page 317, Cleaning the exte-
rior . When the radar sensor starts correctly
detecting again, the message disappears
from the screen and the functions become
available again.
CAUTION
●
If the radar sensor is dirty or poorly adjus-
ted, the Front Assist system may give un-
necessary warnings and apply the brakes
inappropriately.
●
The operation of the radar can be affec-
ted by strong reflections of the emitted sig-
nal. This may occur, for example, in an en-
closed car park or due to the presence of
metallic objects (e.g. guard rails or sheets
used in road works).
●
The sensor may not be adjusted correctly
if it receives an impact. This may compro-
mise the system's efficacy or disconnect it.
If you have the feeling that the radar sensor
is damaged or adjusted incorrectly, switch
off the Front Assist and ACC functions to
avoid any damage. If this occurs have it ad-
justed.
Front camera
Fig. 150
On the windscreen: field of vision of the
Lane Assist system.
Depending on the equipment, the vehicle
may be fitted with a front camera on the
front windscreen
›››
Fig. 150 . This camera
detects lane boundaries (lines) to provide
support for the following functions:
●
Lane Assist
›››
page 233 .
●
Travel Assist
›››
page 235 .
●
Emergency assist
›››
page 238 .
CAUTION
To avoid affecting the operation of the sys-
tems, take the following points into consid-
eration:
●
Clean the field of vision of the camera
regularly and make sure it is free of snow
and ice.
●
Do not cover the field of vision of the
camera.
●
Check that the windscreen is not dam-
aged in the area of the camera's field of vi-
sion.
Rear radar
Fig. 151
Rear view of the vehicle: radar sensor
zones.
Fig. 152
Sensor detection zones
218
To Next Page
