To Next Page

To Previous Page

WHEEL RIM

● Check the wheel rim runout.

SERVICE LIMIT :

RADIAL : 2.0mm replace if over

AXIAL : 2.0mm replace if over

FRONT WHEEL BEARING

INSPECTION

● Turn the inner race of each bearing with your finger to

see if they turn smoothly and quietly Also check if the

outer race fits tightly in the hub.

● Replace the bearings if the races do not turn smoothly,

quietly, or if they fit loosely in the hub.

WHEEL BEARING REPLACEMENT

● Install the bearing remover head and the remover shaft

on the wheel, and remove the bearing and distance

collar.

TOOLS : BEARING REMOVER HEAD

BEARING REMOVER

● Apply sufficient amount of grease to the bearing.

● Insert the right bearing with its seal surface facing

outside.

● Do not tilt the bearing. Insert accurately.

● Upon assembling the distance collar, insert the left

bearing with its seal surface facing outside.

TOOLS : DRIVER HANDLE A

DRIVER PILOT

OUTER DRIVER

14-5

FRONT WHEEL/FRONT FORK/STEERING/BRAKE

·Always replace bearings in pairs, and never use old

bearings.

·The bearing inserted in the last must be inserted until

it contacts with the distance collar.

·Excessively inserted bearing can cause damage the

opposite side bearing.

DIAL GAUGE

BEARING

DAELIM S2 250 Service Manual

Other manuals for DAELIM S2 250