DAELIM S2 250

6-11
COOLING SYSTEM
THERMOSENSOR
REMOVAL
● Remove the seat, met-in box and center cover.
● Drain the coolant.
● Disconnect the thermosensor wire.
● Remove the thermosensor.
·The impeller has left hand thread.
● Install the impeller onto the water pump shaft.
TORQUE VALUE : 0.98~1.37kgf
·
m
● Install the 2 dowel pins and a new gasket.
● Install the water pump cover and tighten the 4 bolts.
TORQUE VALUE : 0.78~1.18kgf
·
m
DOWEL PIN
DOWEL PIN
DOWEL PIN
DOWEL PIN
DOWEL PIN
DOWEL PIN
DOWEL PIN
DOWEL PIN
DOWEL PIN
DOWEL PIN
DOWEL PIN
DOWEL PIN
DOWEL PIN
DOWEL PIN
DOWEL PIN
DOWEL PIN
DOWEL PIN
DOWEL PIN
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
BOLTS
THERMOSENSOR
THERMOSENSOR
THERMOSENSOR
THERMOSENSOR
THERMOSENSOR
THERMOSENSOR
THERMOSENSOR
THERMOSENSOR
THERMOSENSOR
THERMOSENSOR
THERMOSENSOR
THERMOSENSOR
THERMOSENSOR
THERMOSENSOR
THERMOSENSOR
THERMOSENSOR
THERMOSENSOR
THERMOSENSOR