SUSPENSION
FRONT WHEEL
● Hold the brake lever, and compress the front cushion
up and down several times to check the operating
conditions.
● Check the front fork for oil leakage, parts damage or
looseness.
REAR WHEEL
● Compress the near cushion up and down several times
to check the operating conditions.
● Check the rear fork for oil leakage, parts damage or
looseness.
•Do not ride motor cycle with an unsatisfactory
suspension. Loose or worn suspension parts will lead
to deterioration in the vehicle’s safety and operation
efficiency.
2-10
SIDE STAND
● Erect the main stand.
● Pull the lower end of the side stand, and see if it moves
freely.
● If the side stand does not move smoothly, apply grease
to the pivot area.
● If the side stand moves too freely, check the side stand
spring.
● Check the axial movement of the side stand.
INSPECTIONS / ADJUSTMENTS
● Check the side stand ignition cut-off switch :
-Put the side stand up.
-Start the engine.
-Lower the side stand. The engine should stop as you
put the side stand down.
● If there is a problem with the system, check the side
stand switch.
To Next Page
Loading...
Need help?
General
