95XF series Removal and installation
EXPLANATORY NOTES ON THE MAINTENANCE ACTIVITIES
4-15
Removing the poly V-belt (10-rib) of fan and
alternator drive
1. Slacken the attachment bolt (1) in the
clamping block (2) and slacken the
attachment bolt of t he threaded spindle on
the cylinder block.
2. Slacken the attachment bolt (3) in the
alternator support.
3. Turn the lock nuts (4) so that the
compressor is t ilted towards the cylinder
block.
4. Remove the belt through the opening at the
guide ring.
Installing the poly V-belt (10-rib) of fan and
alternator drive
1. Inspect the pulleys for damage, rust and
grease deposits.
2. Fit the new belt through the opening at the
guide ring. Adjust the belt tension, see
chapter “Inspection and adjustment”.
Removing the poly V-belt (6-rib) of the water
pump drive
1. Remove the compressor drive belt.
M2128
1
2
4 4
3
2. Slacken the central nut (1) of the tensioner.
3. By means of bolt (2) move the tension
pulley until the belt can be removed.
Installing the poly V-belt (6-rib) of the water
pump drive
1. Inspect the pulleys for damage, rust and
grease deposits.
2. Fit the new belt and adjust t he belt tension,
see “Inspection and adjustment”.
M2129
2
1
5
200424
To Next Page
Loading...
