User's Manual
224
Information".
Step 1 Click , or click on the configuration page, and then select
DEVICE.
Step 2 Select a remote device and then click Modify IP.
Figure 8-7 Modify IP (1)
Step 3 Enter the IP address, subnet mask, gateway, and incremental value.
●
Enter incremental value only when multiple remote devices are modified. If you want
to change IP addresses of several devices at the same time, system allocates IP address
one by one according to your setting at the fourth bit of the IP address.
●
If there is IP conflict when changing static IP address, device pops up IP conflict
dialogue box. To change IP addresses in batches, system automatically skips the
conflicted IP and begins the allocation according to the incremental value.
Step 4 Enter the username and password of remote device.
When you are changing several device IP addresses, make sure that the username and
password of these remote devices are the same.
Step 5 Click
Next.
The result of IP modification is displayed.
Step 6 Click
OK.
8.2.2.3 Configuring Remote Devices
Set remote device property, connection information, and video parameters.
To Next Page
Loading...
Need help?
General
