User's Manual
254
8.4.1.3 Log
Enable the log function. The system notes down the alarm information in the log when there is
corresponding alarm event.
Click
Actions and select Log to enable this function.
Figure 8-39 Log
When log function is enabled, after an alarm is triggered, click on LIVE page, select MAINTAIN >
Log > Event.
8.4.1.4 Email
Enable Email function. The system sends alarm email to all added receivers when there is
corresponding alarm event.
Make sure that the email configuration has been completed. See "8.3.2.3 Email" for detailed
information.
Click
Actions and select Email to enable this function.
Figure 8-40 Email
8.4.1.5 Preset
Set preset function. The system links the selected remote device to rotate to the designated preset
point when there is corresponding alarm event.
Make sure that the PTZ device has been added, and preset has been added. See "5.4.2 Adding
Remote Device" for detailed information.
Step 1 Click Actions and select Preset.
Figure 8-41 Preset
Step 2 Select PTZ device, and enter preset number.
Step 3 (Optional) Repeat Step 1–Step 2, and link multiple PTZ devices to turn to designated
presets.
To Next Page
Loading...
Need help?
General
