Local Configurations 221
Select the check box to enable a tour of the selected channels.
To use this function, make sure the tour is enabled and configured
in Main Menu > DISPLAY > TOUR.
Select to enable audio broadcast/voice prompts in response to a
temperature alarm event.
Show Message: Select the Show Message check box to
enable a pop-up message in your local host PC.
Buzzer: Select the check box to activate a buzzer noise at the
Device.
Video Matrix: Select the check box to enable the function.
When an alarm event occurs, the video output port outputs the
settings configured in "Main Menu > DISPLAY > TOUR."
Not all models support this function.
Send Email: Enable the system to send an email notification
when an alarm event occurs.
To use this function, make sure the email function is enabled in
Main Menu > NETWORK > EMAIL.
Log: Select the check box to enable the Device to record a
local alarm log.
Select the check box to enable the function. When an alarm
event occurs, the extra screen outputs the settings configured
in Main Menu > DISPLAY > TOUR > Extra Screen.
Not all models support this function.
To use this function, extra screen shall be enabled.
Table 5-53
Click Save to save the settings. Step 4
5.12.2.4.2 Configuring Alarm Settings for Humidity Data
You can configure the alarm event by setting the humidity data.
On the main interface, select IoT > MANAGER > Temperature/Humidity.
Step 1
The Temperature/Humidity interface is displayed. See Figure 5-187.
To Next Page
Loading...
Need help?
General
