Dahua DH-XVR1B08 User Manual

Local Configurations 289
Parameter
Description
Mobile Phone Push
If you enable this function, the snapshots that are activated
by the alarm event on the Device can be sent to mobile
phone.
This function is enabled by default.
CGI
If this function is enabled, the remote devices can be added
through the CGI protocol.
This function is enabled by default.
ONVIF
If this function is enabled, the remote devices can be added
through the ONVIF protocol.
This function is enabled by default.
Audio/Video Transmission
Enable or disable the audio and video stream encryption.
 If enabled, make sure the devices or software support
decryption.
 The audio and video data with third-party platform or
device cannot be encrypted for transmission. To
guarantee audio and video data safety, it is
recommended to disable CGI and ONVIF services.
Table 5-78
Click Apply to complete the settings. Step 3
5.19.4 Configuring System Maintenance Settings
When the Device has been running for a long time, you can configure the auto reboot when the
Device is not working. You can also configure the case fan mode to reduce noise and extend
the service life.
Select Main Menu > SYSTEM > SYSTEM MAINTAIN. Step 1
The SYSTEM MAINTAIN interface is displayed. See Figure 5-263.

Dahua DH-XVR1B08 Specifications

General

Audio Input	1 channel, RCA
Audio Output	1 channel, RCA
Video Output	1 HDMI, 1 VGA
USB	2 USB 2.0 ports
Power Supply	DC12V/1.5A
Video Compression	H.265/H.264
Analog Camera Input	8 channels, BNC
IP Camera Input	8
HDD	1 SATA port, up to 6TB
Network	1 RJ-45 port (10/100 Mbps)
Operating Temperature	-10°C to +55°C
Operating Humidity	10% to 90%
Max Recording Resolution	1080N/720p/960H/D1/CIF