Local Basic Operation 115
Figure 4-51
Step 8 Set camera IP address.
Check DHCP, there is no need to input IP address, subnet mask, and default
gateway. Device automatically allocates the IP address to the camera.
Check Static, and then input IP address, subnet mask, default gateway and
incremental value.
If it is to change several devices IP addresses at the same time, input incremental
value. Device can add the fourth address of the IP address one by one to
automatically allocate the IP addresses.
If there is IP conflict when changing static IP address, device pops up IP conflict
dialogue box. If batch change IP address, device automatically skips the conflicted
IP and begin the allocation according to the incremental value
Step 9 Click Next button.
The Device Initialization interface is displayed. See Figure 4-52.
To Next Page
Loading...
Need help?
General
