User's Manual
100
Figure 5-7 Search device
●
To view the live image of a camera, click
LIVE
and then enter the username and
password. You can only view live images of cameras accessed through private
protocol.
●
To filter the remote devices, select device name from the
Filter
drop-down list.
●
To filter out the uninitialized devices, click the
Not Initialized
tab, and then you can
initialize the devices remotely.
●
To view all remote devices added through plug and play, click the
Not Auto
Connected
tab. You can remove devices added through plug and play, and they
can be automatically added again after plug and play is enabled.
2) (Optional) Enable
Plug and Play
.
When
Plug and Play
is enabled, the Device automatically adds cameras on the same
LAN.
For uninitialized cameras, the Device automatically initializes them before adding
them.
3) Enable
H.265 Auto Switch
When
H.265 Auto Switch
is enabled, the video compression standard of added remote
devices is switched to H.265 automatically.
4) Double-click a camera, or select a camera and then click
Add
to register it to the
Added
Device
list.
5) Click
Next
.
Step 5 Manage HDD. You can view HDD name, physical position, health status, capacity, and
more.
To Next Page
Loading...
Need help?
General
