Dahua JRC-27F

User's Manual
277
●
Zone 3 displays the status information of the 3G/4G module.
Zone 2 displays the corresponding information when the 3G/4G module is connected,
while Zone 1 and Zone 3 will only display the corresponding content when the 3G/4G is
enabled.
Step 2 Configure parameters.
Table 5-55 3G/4G parameters
Parameter Description
NIC Name Select a NIC name.
Network Type.
Select a 3G/4G network type to distinguish between 3G/4G modules
from different vendors.
APN, Dial-up No. Main parameters of PPP dial.
Authentication Type
Select PAP, CHAP or NO_AUTH. NO_AUTH represents no
authentication for 3G/4G.
Step 3 Click
Apply
.
5.11.7 Cellular Network
Connect the Device to mobile network and view network status and traffic of the cellular network.
Prerequisites
A SIM card is inserted in the recorder.
This function is available on select models.
Procedure
Step 1 Select
Main Menu
>
NETWORK
>
Cellular Network
>
Cellular Network
.
Step 2 Enable cellular network and configure parameters.