User's Manual
143
Step 2 (Optional) Enable
H.265 Auto Switch
.
When
H.265 Auto Switch
is enabled, the video compression standard of added remote
devices is switched to H.265 automatically.
Step 3 Click
Manual Add
.
Figure 5-56 Manual add
Step 4 Configure the parameters.
The parameters might vary depending on the manufacturer that you select.
Table 5-15 Remote channel parameters
Parameter Description
Channel
Select the channel that you want use on the Device to connect the
remote device.
Manufacturer Select the manufacturer of the remote device.
IP Address Enter the IP address of the remote device.
RTSP Port Enter the RTSP port number. The default value is 554.
HTTP Port Enter the HTTP port number. The default value is 80.
TCP Port The default value is 37777. You can enter the value as needed.
Username Enter the username of the remote device.
Password Enter the password of the user for the remote device.
Total Channels
Click
Connect
to get the total number of channels of the remote
device.
Remote CH No. Enter the remote channel number of the remote device.
To Next Page
Loading...
Need help?
General
