Spyder3 SG-34 GigE Vision Color Manual 91
Teledyne DALSA 03-032-20124-00
Appendix C: EMC Declaration
Teledyne Dalsa's SG-34 cameras meet the requirements outlined below which satisfy the EMC
requirements for CE marking, the FCC Part 15 Class A requirements, and the Industry Canada
requirements.
The CE Mark Evaluation of the SG-34 Camera, which is manufactured by Teledyne Dalsa Inc., meets
the following requirements:
EN 55022 , EN 55011 , and FCC Part 15 Class A Emissions Requirements
EN 61326-1 and EN 55024 Immunity to Disturbances
Models SG-34-02k 40 and 80
The CE Mark, FCC Part 15, and Industry Canada ICES-003 Evaluation of the SG-34 Camera meets the
following requirements:
EN 55022 Class A, and EN 61326 Emissions Requirements
EN 55024, and EN 61326 Immunity to Disturbances
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at the user's own expense.
Changes or modifications not expressly approved by Teledyne DALSA could void the user's authority to
operate the equipment.
Name and Signature of authorized person
Hank Helmond
Quality Manager, Teledybe DALSA Inc.
All manuals and user guides at all-guides.com
all-guides.com
To Next Page
Loading...
Need help?
General
