EasyManua.ls Logo

Danfoss TTS300

Danfoss TTS300
294 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Table 5-2 Compressor Fault Types
Compressor Status Fault Description
InverterTemperature ThemeasuredInvertertemperaturehasexceededthefaultlimit.
DischargeTemperature Themeasureddischargetemperaturehasexceededthefaultlimit.
SoftStartTemperature ThemeasuredSoftStarttemperaturehasexceededthefaultlimit.
LowSuctionPressure Themeasuredsuctionpressurehasexceededthefaultlimit.
DischargePressure Themeasureddischargepressurehasexceededthefaultlimit.
Instantaneouslock-out,pre-CC4.0.0.
3-PhaseOver-Current Thecalculated3phasecurrenthasexceededthefaultlimit.
Instantaneouslock-out,pre-CC4.0.0.
CavityTemperature Themeasuredcavitytemperaturehasexceededthefaultlimit.
LeavingFluidTemperature Thelowestacceptablemeasuredleavingfluidtemperaturehasbeenexceeded.
(RemovedfromCC4.X.Xsoftware)
PressureRatio Thecalculatedpressureratioofdischarge/suctionhasexceededthefaultlimit.
Bearing/MotorFaultActive IfaMotorFaulttypeoraBearingFaulttypeispresent,thentheBearing/MotorFaultActiveistriggered.Thisis
notanactualfault,onlyanindicationthatamotororbearingfaulttypehasoccurred.
SensorFault Ifthefollowingmeasuredtemperatures(in°C)orpressuresin(kPaabs)aresurpassed,asensorfaultistriggered:
InverterTemperature:>100or<0°C
CavityTemperature:>100or<-20°C
SuctionTemperature:>100or<-30°C
DischargeTemperature:>110or<-30°C
LeavingFluidTemperature:>100or<-20°C
SuctionPressure:>1200or<-30kPaabs
DischargePressure:>3500or<-30kPaabs
SCRTemperature ThemeasuredSCRtemperaturehasexceededthefaultlimit.
(FaultandAlarmremovedfromCC4.2.Xandlatersoftware)
LockOutFault Lock-Outfaultsrequirepowercycletoreset.
Instantaneouslockouts:
InverterError-CC4.X.X
DischargePressure-preCC4.0.0
3PhaseOverCurrent-preCC4.0.0
Ifany(oracombinationof)thefaultslistedbelowoccursmorethan3timeswithin30minutes,aLock-Outfault
occurs:
DischargePressure-CC4.X.X
3-PhaseOvercurrent-CC4.X.X
InverterTemperature
SCRTemperature
MotorOvercurrent
InverterError-preCC4.0.0
RotorStartingTorque
LowMotorBackEMF
WindingTemperature Themeasuredmotorwindingtemperaturehasexceededthefaultlimit.
HighSuctionSuperheat ThecalculatedSuctionSuperheatTemperaturehasexceededtheFaultlimit.
Page 252 of 294 - M-SV-001-EN Rev. H 1/23/2023

Table of Contents

Other manuals for Danfoss TTS300

Related product manuals