10-23 COS Filter 4
Range: Function:
0* [0 - 65535 ] Enter the value for COS lter 4 to set up the
lter mask for PCD 4. When operating in COS,
this function lters out bits in PCD 4 that
should not be sent if they change.
3.11.4 10-3* Parameter Access
Parameter group providing access to indexed parameters
and dening programming set-up.
10-30 Array Index
Range: Function:
0* [0 - 255 ] View array parameters. This parameter is valid
only when a VLT
®
DeviceNet MCA 104 is installed.
10-31 Store Data Values
Option: Function:
Parameter values changed via DeviceNet are not
automatically stored in non-volatile memory. Use
this parameter to activate a function that stores
parameter values in the EEPROM non-volatile
memory, so changed parameter values are
retained at power-down.
[0] * O Deactivates the non-volatile storage function.
[1] Store edit
setup
Stores all parameter values from the active set-
up in the non-volatile memory. The selection
returns to [0] O when all values have been
stored.
[2] Store all
setups
Stores all parameter values for all set-ups in the
non-volatile memory. The selection returns to [0]
O when all parameter values have been stored.
10-32 Devicenet Revision
Range: Function:
Size related* [0 - 65535 ] View the DeviceNet revision number.
This parameter is used for EDS le
creation.
10-33 Store Always
Option: Function:
[0] * O Deactivates non-volatile storage of data.
[1] On
Stores parameter data received via VLT
®
DeviceNet
MCA 104 in EEPROM non-volatile memory as default.
10-34 DeviceNet Product Code
Range: Function:
0 N/A* [0 - 65535 N/A]
10-39 Devicenet F Parameters
Array [1000].
No LCP access.
Range: Function:
0* [0 - 0 ] This parameter is used to congure the frequency
converter via VLT
®
DeviceNet MCA 104 and to
build the EDS le.
Parameter Description
VLT
®
AQUA Drive FC 202
112 Danfoss A/S © 05/2018 All rights reserved. MG20OB02
33
To Next Page
Loading...
Need help?
General