Datafox Evo 4.3 - Page 68

Manual Datafox Evo 4.3 Page 62 Date: 27.12.2017 V 04.03.09.XX
Start an input sequence in the device signal processing
The keyword, if you need in the SMS is:
ek=name&key=ja (the name of the input sequence).
The name of the input sequence must match completely, otherwise it will not run.
Receive the device an SMS with this text, then start the input sequence.
If save a SMS Key, the must included the SMS this Key (&key=ja).
With this are many different variants are possible.
Here some example:
Open a door via SMS.
Control a technical system and send a SMS in trouble:
Is the level of regulation from the system not correct then gives a report via SMS.
The Datafox MasterIV is here not the regulator. He gives only a report in trouble.
If necessary, a procedure also can be done.
!
Caution:
There is no 100% guarantee that a sent text message reaches the receiver. This is only
an example which is intended to represent the possibilities.
SMS from
device to you
oversize the
level
you can activate a
action
SMS to the
device
The Datafox-device
switch on a pump.
check
SMS
open the door