Manual Datafox Evo 4.3 Page 83 Date: 27.12.2017 V 04.03.09.XX
The following information can be called up in the general con-
figuration:
- Installed firmware, serial number
- Memory allocation for the image memory
- Transponder test for the transponder configured in the mas-
ter setup.
5.7.5.5. Bios-menu
Connect the reader to the 12V power supply with the connecting cable.
As soon as it is started, connect the reader via USB to a PC or a small battery (power bank).
The Bios menu can only be accessed when the USB port is powered.
Tap both top left and bottom right at the same time.
5.7.5.6. General configuration
USB port on the back of the
reader
To Next Page
Loading...
