2D Symbologies Enter/Exit Programming Mode
Product Reference Guide
201
PDF417 Set Length 1
Specifies one of the bar code lengths for PDF417 Length Control. Length 1 is the minimum
label length if in Va
riable Length Mode, or the first fixed length if in Fixed Length Mode.
Length includes the bar code’s data characters only. Characters can be set from 0001 to 2,710
characters (pad with zeroes) in increments of 01. Any value greater than 2,710 will be
considered to be 2,710.
See page 253 for detailed instructions on setting this feature.
Select PDF417 Length 1 Setting
To configure this feature, scan
the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at
left followed by the digits from the Alphanumeric
characters in
Appendix E, Keypad representing your
desired character(s). End by scanning the ENTER/EXIT
bar co
de again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
0001 = Length 1 is 1 Character
To Next Page
Loading...
