Datalogic Gryphon I GFS4400 - Good Read LED Duration

Reading Parameters Enter/Exit Programming Mode
Product Reference Guide 79
Good Read LED Duration
This feature specifies the amount of time that the Good Read LED remains on following a good
read. The good read LED on time can be set within a range of 100 milliseconds to 25,500
milliseconds (0.1 to 25.5 seconds) in 100ms increments. A setting of 00 keeps the LED on until
the next trigger push.
See page 267 in “References” for detailed instructions and examples for setting
this feature.
$CLAGL00(CR)
Good Read LED Duration Setting =
Keep LED on until next trigger push
$CLAGL
Select Good Read LED Duration Setting
To configure this feature, scan the ENTER/EXIT PROGRAM-
MING MODE bar code above, then the bar code at left fol-
lowed by the digits from the Alphanumeric characters in
Appendix E, Keypad representing your desired charac-
ter(s). End by scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to
abort and
not save the entry string. You can then start again at the
beginning.
~
CANCEL
DEFAULT
003 = Good Read LED
stays on for 300 ms.