Datalogic Gryphon I GFS4400 - Illumination on Time; Scanning Active Time

Reading Parameters Enter/Exit Programming Mode
Product Reference Guide 85
Illumination On Time
Defines the amount of time illumination is kept ON after a label is decoded. If an object is
detected before Illumination ON expires, the timer is refreshed with the Object Gone timeout
value. Range is 0 millisecond to 25.5 milliseconds in 100 millisecond intervals.
$CSNON
Select Presentation Mode Time Setting
To configure this feature, scan the ENTER/EXIT PROGRAM-
MING MODE bar code above, then the bar code at left fol-
lowed by the digits from the Alphanumeric characters in
Appendix E, Keypad representing your desired charac-
ter(s). End by scanning the ENTER/EXIT bar code again.
DEFAULT
1 Second
This configuration is available in Automatic (Object Sense) only.
Scanning Active Time
This setting specifies the amount of time that the reader stays in scan ON state once the state is
entered. The range for this setting is from 1 to 255 seconds in 1-second increments. See
page 270 in “References” for further description of this feature.
$CSNET03(CR)
Scanning Active Time = 3 seconds
$CSNET05(CR)
Scanning Active Time = 5 seconds
DEFAULT
$CSNET08(CR)
Scanning Active Time = 8 seconds
Scanning Active Time works in On Line and Serial On Line Read modes as
the Timeout Phase Off Event. See also
" Phase Off Timeout" on page
81
.