Datalogic Gryphon I GFS4400 - Aiming Duration Timer; Green Spot Duration

Reading Parameters Enter/Exit Programming Mode
Product Reference Guide 87
Aiming Duration Timer
Specifies the frame of time the aiming pointer remains on after decoding a label, when in On
Line or Serial On Line mode.The range for this setting is from 1 to 255 seconds in 1-second
increments. See page 271 in “References” for a description of this feature.
DEFAULT
LSTM00
Aiming Off After Decoding
LSTM
Set Aiming Duration Timer
To configure, scan the ENTER/EXIT PROGRAMMING MODE
bar code above, then the bar code at left followed by the
digits from the Alphanumeric characters in Appendix E,
Keypad representing your desired character(s). End by
scanning the ENTER/EXIT bar code.
Make a mistake? Scan the CANCEL bar code to
abort and
not save the entry string. You can then start again at the
beginning.
~
CANCEL
Green Spot Duration
Specifies the duration of the good read pointer beam after a good read.
$CLSSP00(CR)
Green Spot Duration = Disable (Green Spot is Off)
$CLSSP01(CR)
Green Spot Duration = Short (300 msec)
DEFAULT
$CLSSP02(CR)
Green Spot Duration = Medium (500 msec)
$CLSSP03(CR)
Green Spot Duration = Long (800 msec)