Datalogic Gryphon I GFS4400 - Phase off Event; Phase off Timeout

Reading Parameters Enter/Exit Programming Mode
Product Reference Guide 81
Phase Off Event
$CSPTO00\r
Trigger Stop
DEFAULT
$CSPTO01\r
Timeout
$CSPTO02\r
Trigger Stop - Timeout
Phase Off Timeout
Timeout can be set within a range of 1second to 255 seconds in 1 second intervals.
$CSNET
Scanning Active Time
To configure this feature scan the ENTER/EXIT PROGRAMMING
MODE barcode above, then the barcode at left, followed by
the digits (in hex) from the Alphanumeric characters in
Appendix E, Keypad representing your desired charac-
ter(s). End by scanning the
ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode to abort and not
sav
e the entry string. You can then start again at the begin-
ning.
~
CANCEL
DEFAULT
5 = Timeout set for 5 seconds