Datamax I-Class Mark II Maintenance Manual

55
I-Class Mark II Maintenance Manual Removal and Replacement
4. Carefully separate the Lower Carriage from the Printhead Assembly, compressing the spring-loaded
assembly as necessary to separate the parts, and then remove the Alignment Springs.
Printhead
Assembly
Lower
Carriage
Alignment
Springs
5. Separate the Middle Carriage from the Upper Carriage then remove the Cams and the Pressure Springs.
Upper
Carriage
Middle
Carriage
Cams
Pressure
Springs

Datamax I-Class Mark II Specifications

General

Power Supply	100-240 VAC, 50-60 Hz
Print Resolution	203 dpi
Print Width	4.09 inches
Memory	16 MB DRAM, 8 MB Flash
Connectivity	USB, Serial, Ethernet
Media Handling	Roll-fed
Media Width	1.0" – 4.65" (25.4 mm – 118 mm)
Media Thickness	0.0025" – 0.010" (0.0635 mm – 0.254 mm)
Ribbon Width	1.0" – 4.5" (25.4 mm – 114.3 mm)
Ribbon Length	1968 feet (600 meters)
Print Speed	up to 12 ips
Dimensions	12.7" H x 12.6" W x 18.6" D (322.6 mm H x 320 mm W x 472.4 mm D)