Datasat LS10 - Page 104

LS10 Installation and Operating Guide Version 1.01
Appendix E. LS10 Remote Command API E-7 Document #: 9301H66300 Ver. 1.01
Parameters
value Selection
0
Turn off pink noise.
1
Automatically sequence pink noise through each
channel.
2
Manual mode: Enable pink noise with manual stepping
through channels.
3
Channel Step. Advance to the next channel in the
sequence and return to manual mode (value will be 2
when read from the command).
Example
Start automatic pink noise sequence.
Send: @NOISESEQ 1<cr>
Receive: NOISESEQ 1<cr>
Turn off pink noise.
Send: @NOISESEQ 0<cr>
Receive: NOISESEQ 0<cr>
Audio Decoder Configuration
1. Processing Mode
Select processing function between None, DTS NeoX, Dolby Pro Logic II or IIx, Dolby Pro
Logic IIz, or Auro-3D.
Command: @DECODERPOST [mode]<cr>
Operation
Response: DECODERPOST [mode]<CR>
Read/Write
Parameters
[mode] Selection Valid Speaker Configurations(1)
0
Off/None Any
3
DTS Neo:X All, except 2.0 or 2.1
4
Dolby PLII, or
Dolby PLIIx
Not Available for 2.0 or 2.1
PLIIx for all configuration with LB/RB
PLII for all other configurations
5
Dolby PLIIz Must include High Left / High Right
6
Auro-3D (2) Auro 9.1, Auro 10.1, Auro 11.1 or Auro
13.1,
2.0, 2.1, 5.1, 7.1.