Datasat LS10 - Page 105

LS10 Installation and Operating Guide Version 1.01
Appendix E. LS10 Remote Command API E-8 Document #: 9301H66300 Ver. 1.01
Notes:
(1) The mode will not change when the selected mode is not valid for the current speaker
configuration.
(2) Auro-3D is available only on units with the Auro-3D upgrade option installed.
Sub Configurations
DTS Neo:X See the command NEOXMODE for details on configuration item
available only with DTS Neo:X.
Dolby PLIIx See the command DPL2MODE for details on Pro Logic IIx
configuration items.
Dolby PLIIz See the command DPL2HEGAIN for details on and additional Pro
Logic IIz configuration item.
Example
Enable Auro-3D.
Send: @DECODERPOST 6<cr>
Receive: DECODERPOST 6<cr>
2. Neo:X Mode
Select Neo:X mode to Cinema, Music or Game. The Neo:X mode selection is in affect only
when the Post Processing Mode (DECODERPOST) is set for Neo:X.
Command: @NEOXMODE [value]<cr>
Operation
Response: NEOXMODE [value]<CR>
Read/Write
Parameters
[value] Selection
0
Cinema
1
Music
2
Game