Datasat LS10 - Page 113

LS10 Installation and Operating Guide Version 1.01
Appendix E. LS10 Remote Command API E-16 Document #: 9301H66300 Ver. 1.01
General Commands
1. System Information
Returns system versions and MAC address
Command: @SYSTEM <cr>
Operation
Response: VER<space>version<LF>
VERDATE<space>date<LF>
MAC<space>mac address<CR>
Read
Parameters
version
Software version number
date
Software date/time
mac address
LS10 MAC address
2. Identify
Get system identify information. Mostly used in discovery protocol.
Command: @IDENTIFY<cr>
Operation
Response: LS10<space>IP<space>[screen]<cr>
Read
Parameters
LS10 General identifier for Datasat audio processor product. XZ
ip
IP address (useful after network broadcast command)
[Screen] User defined ID string, if entered in the LS10 configuration.
3. Model
Determines that the Datasat Audio processor is an LS10.
Command: @MODEL<cr>
Operation
Response: MODEL<space>LS10<cr>
Read
Parameters
LS10
An LS10 returns this model string.
4. Authorization
Command: @AUTH<space>[Password]<cr>
Operation
Response:
AUTH<space>[SETUP|OP|SECERR]<cr>
Read
Give a password to allow usage of restricted commands. The authorization is required for
many commands if access to the LS10 has been configured with a Password. The AUTH
must be issued before issuing any password protected commands, and is valid only for the
duration of the TCP/IP connection.
Note: This application accepts only Latin alphanumeric characters.