Maintenance Alarm
92
7.10 MAINTENANCE ALARM
Depending upon module configuration one or more levels of maintenance alarm may occur based
upon a configurable schedule.
Example 1
Screen capture from DSE Configuration Suite
Software showing the configuration of
Maintenance Alarm 1 and Maintenance Alarm
2.
When activated, the maintenance alarm can
be either a warning (set continues to run) or
shutdown (running the set is not possible).
Resetting the maintenance alarm is normally
actioned by the site service engineer after
performing the required maintenance.
The method of reset is either by:
• Activating a input that has been
configured to maintenance x reset,
where x is the number of the
maintenance alarm (1 to 3).
• Pressing the maintenance reset button
in the DSE Configuration Suite,
Maintenance section.
Example 2
Screen capture from DSE Configuration Suite
Software showing the configuration of a digital
input for Reset Maintenance Alarm 1.
Example 3
Screen capture from DSE Configuration Suite
Software showing the Maintenance Alarm
Reset ‘button’ in the DSE Configuration Suite
SCADA | MAINTENANCE section.
To Next Page
Loading...
Need help?
General
