Front Panel Configuration
96
9.1.1 EDITING A PARAMETER
• Enter the editor as described above.
• Press the (up) (down) and (right) to cycle to the section you wish to
view/change.
• Then press (up) or (down) to cycle to the parameter within the section you have
chosen.
• To edit the parameter, press to enter edit mode. The parameter begins to flash to
indicate that you are editing the value.
• Press the up or down buttons to change the parameter to the required value.
• Press to save the value. The parameter ceases flashing to indicate that it has been
saved.
• To exit the editor at any time, press and hold the or button.
NOTE: - The editor automatically exits after 5 minutes of inactivity to ensure security.
NOTE: - The PIN number is automatically reset when the editor is exited (manually or
automatically) to ensure security.
NOTE: - More comprehensive module configuration is possible using the DSE8800 series
PC configuration software – DSE Part 057-164. Please contact us for further details.
To Next Page
Loading...
