Inputs
Oil Pressure Low Oil Pressure Shutdown Trip 0.00 Bar
Warning Trip 0.00 Bar
Coolant Temperature High Coolant Alarms Pre-Alarm Trip 00 Deg C
Electrical Trip 00 Deg C
Shutdown Trip 00 Deg C
Low Coolant Alarms Pre Alarm Trip 00 Deg C
Fuel Level Fuel Usage Alarm Running Rate Up / down
Stopped Rate Up / down
Timers
Start Timers Start Delay Remote Start Off Load s
Remote start On Load s
Telemetry Start s
Start Timers Preheat s
Cranking Time s
Crank Rest Time s
Smoke Limit s
Smoke Limit Off s
Safety on Delay s
Warming up Timer s
Stopping Timers Stopping Timers Return Delay s
Cooling Time mm:ss
Fail To Stop Delay 0s
Gen Transient Delay 0s
Display Page Timer mm: ss
Scroll Timer s
Generator
Generator Options AC System
3 Phase, 4 wire Delta
2 Phase, 3 Wire L1-L3
2 Phase, 3 Wire L1-L2
3 Phase, 3 Wire
Single Phase, 2 Wire
3 Phase, 4 Wire
Generator Rating KW Rating 0 KW
kVAr Rating 0 kVAr
Generator Current Current Options CT Primary (L1,L2,L3,N) 0A
CT Secondary 5Amp / 1 Amp 5 / 1 Amp
Full Load Rating 0A
Earth Fault Earth CT Primary 0A
Trip Action Enabled / Disabled
Trip Percentage 0%
Over Current Alarm IDMT Alarm Enabled / Disabled
Trip 0% 0.0A
Short Circuit Trip 0% 0.0A
Generator Voltage Under Voltage Alarms Alarm Trip 0%
Pre-Alarm Trip 0A
Nominal Voltage Nominal Voltage 0V
Over Voltage Alarms Pre-alarm ttrip 0V
Alarm Trip 0V
Generator Frequency Under Frequency Alarms Alarm Trip
Pre-Alarm Trip
0.0Hz
0.0Hz
Nominal Frequency Nominal Frequency 0.0Hz
Pre-Alarm Trip
Alarm Trip
0.0Hz
0.0Hz
Generator Power Overload Protection Overload Protection Trip 0% (0 kW)
Reverse Power Trip (Delay) 0kW (0.0 s)
Synchronising Load Control
Reactive Load Mode
KVAr Fixed Export
kVAr Share
None
Ramp Speed Ramp Speed 0.0 %/s
Load Demand Calling For More Sets 0 %
Calling For Less Sets 0 %
Insufficient Capacity Action
Warning / Shutdown / None
/ Indication / Electrical Trip
Engine
Engine Options Overspeed Options Overspeed Overshoot 0%
Overshoot Delay s
Droop Enable Enabled / Disabled
Percent 0.0%
Speed Settings Under Speed Alarm Enable Enabled / Disabled
Alarm Trip 0000 RPM
Warning Enable Enabled / Disabled
Warniing Trip 0000 RPM
Over Speed Alarm Trip 0000 RPM
Pre-Alarm Enable Enabled / Disabled
Pre-Alarm Trip 0000 RPM
Plant Battery Under Voltage Alarms Under Volts Enable Enabled / Disabled
Under Volts Delay mm:ss
Under Volts Pre-Alarm 0.0v
Over Voltage Alarms Over Volts Enable Enabled / Disabled
Over volts Delay mm:ss
Over Volts Pre-Alarm 0.0v
Charge Alt Alarm Alarm Enable Enabled / Disabled
Alarm Trip 0.0v
Alarm Delay s
Charge Alt Pre-Alarm Pre-Alarm Enable Enabled / Disabled
Pre-Alarm Trip 0.0v
Pre-Alarm Delay s
Alt. Config Options
Default Configuration
Alternative Configuration 3
Alternative Configuration 2
Alternative Configuration 1
Main Configuration
9.2 ACCESSING THE ‘MAINTENANCE’ CONFIGURATION EDITOR
To Next Page
Loading...
Need help?
General
