Front Panel Configuration
95
9.1 ACCESSING THE MAIN FRONT PANEL CONFIGURATION EDITOR
• Ensure the engine is at rest and the module is in STOP mode by pressing the
Stop/Reset button.
• Press and hold the the Stop button and Tick button together.
• If a module security PIN has been set, the PIN number request is then
shown .
• Press , the first ‘#’ changes to ‘0’. Press (up) or (down) to adjust it to the
correct value.
• Press (right) when the first digit is correctly entered. The digit you have just entered
will now show ‘#’ for security.
• The other digits of the PIN number. You can press (left) if you need
to move back to adjust one of the previous digits.
• When is pressed after editing the final PIN digit, the PIN is checked
for validity. If the number is not correct, you must re-enter the PIN.
• If the PIN has been successfully entered (or the module PIN has not been enabled), the
editor is displayed.
• To edit the parameter, press to enter edit mode. The parameter begins to flash to
indicate that you are editing the value.
• Press the up or down buttons to change the parameter to the required value.
• Press to save the value. The parameter ceases flashing to indicate that it has been
saved.
• To exit the editor at any time, press and hold the or button.
NOTE: The PIN number is not set by DSE when the module leaves the factory. If the
module has a PIN code set, this has been affected by your generator supplier who
should be contacted if you require the code. If the code has been ‘lost’ or ‘forgotten’,
the module must be returned to the DSE factory to have the module’s code removed. A
charge will be made for this procedure.
To Next Page
Loading...
Need help?
General
